Two Wheel Drive Economy Class 6200lb
- Engine must have one carburetor and not exceed 485 ci. Must run on pump fuel.
- Engine must have all OEM cast iron heads and block. No alum. heads or aftermarket block.
- Safety loops are required around all yokes and universal joints. Min 5/16" thick for steel, 3/8" thick for alum. and 6" wide. Min. of 1 loop around driveshaft, min. of 1" wide. Two piece driveshafts need one loop per section.
- Must have an operational kill switch
- Hitch must be a min. of 36" from center of rear axle to hook point. Max. of 30" high and stationary in all directions. Pin point not to exceed 10 degrees total elevation in height from hook point.
- Steel bell housing of SFI 6.1 or greater required. No mods. to the bell housing are allowed, it must be completely enclosed, and have a block plate. Automatic transmissions must have a SFI approved blanket or shields. All shields must be in place including dust shields.
- Any part of the vehicle not to exceed 15ft. from the center of the rear hub.
- Nitrous oxide is not permitted.
- Must have a cover over the bed if any part of the bed has been removed.
- Alum. or steel deflection shields must be mounted on each side of the engine. They must run the complete length of the engine block and be a min of .060 thick.
- After market or prefab gear boxes or planetary rear ends are not allowed. OEM transfer cases or two speed rear ends will be permitted but limited to one or the other. Not both.
- Max. tire size is 34 x 18
- Must have a bumper or bumper pads
- No stepping up to the next class.
- Fire suits must be worn and they must meet or exceed 3.2 A-1 performance specs.
- Must have and wear a safety belt.