Sign up for our mailing list

6700 lb. Hot Tractor


  1. Open to agricultural farm tractors with rubber tires.  No 4wd or dual wheels. 
  2. Tires limited to 20.8 x 38 or 24.5 x 32  Cut tires allowed
  3. Tractor must have original frame.  No extended frame rails.  Must have same engine required for the tractor from orig. manufacture.  Must fit the original bell housing with no alterations.
  4. Engine limited to 350 cid.  Must have mech. injection on diesels and carburetor on gas engines.  Tractor can run diesel, gas or propane but must run the fuel it ran when it came from the factory.  One turbo allowed.  Must have two 3/8" bolts crossed in exhaust to stop any parts from turbo from blowing out.  No P pumps.  Injection pump to remain in factory location.  Must have a throttle stop on pump.
  5. Max rpm limit of 4000.  Must have a recall or memory tach to check rpm.  No flammable liquids or oxygen making additives injected into the engine.  No propane injection.
  6. Draw bar height of 20" to hook point.  18" from center of wheel to hook point, fixed in all directions.  No floating draw bars.  Must have wheelie bars 6" min. from cleat on tire to back of pad.  10" max height, 20" min. distance between pads side to side.  Wheelie bars must be able to support weight of the tractor when jacking by the pads. 
  7. Tractor must have kill switch located as close to rear and center of tractor above weights with no interference.  Must have a 2" ring in kill switch for hooking safety cable. 
  8. Wide front ends only, no single wheel tractors.  Weights or racks not to extend more than 24" from furthest point of factory grill.  No weights past rear tires.  Tractor must remain within 6" of factory wheel base.  Must have factory appearing sheet metal, no alum. or fiberglass parts unless original from factory.  Must have fenders that will support the weight of the driver.  Must have side shields that cover the entire engine.
  9. Factory cooling are highly not recommended.  Fan blades must be fully surrounded with a steel safety shield.  This does not include the side shields. 
  10. Puller is responsible to provide proof of tractors eligibility (parts book).  All drivers must wear a helmet.
  11. All other truck safety rules apply to this class.
Site Design by: Luna Web Design